usemodem7

4 Dirty Little Details About The Peugeot 308 Key Fob Industry
Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a little however, it's still eye-catching. It might not be the most luxurious car in its class and an Ford Focus or Volkswagen Golf will shield you from road imperfections, but it's a relaxed and civilised driving experience.

We are often asked at Coded Car Keys to replace peugeot key fobs. No matter if the issue is persistent or intermittent these tips will assist.

Water Damage

When you accidentally leave your fob in a puddle or get it wet during kayaking, swimming, canoeing, rafting, or canyoning, it's likely to suffer water damage. Keep your key fob in a dry, dry bag each time you are outdoors or engage in activities that expose it to a lot of water.

You should also ensure that the fob is completely dry before opening it up and using it again. If you detect any smells emanating from the fob such as an industrial-type liquid smell or the scent of windshield washer fluid, it's another indication that it's been submerged in water.

A circuit that is wet can cause the battery's energy to drain or even explode. If you can pull your keyfob 308 out of the water you need to turn the button side up and shake as much water as possible before opening the casing. Take the battery out, and then wipe the circuit board clean using a cotton swab that has been submerged in 90 percent alcohol.

Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell, receiver module problems signal interference, or a defective chip. If none of these are the issue, try resetting the system by disconnecting the battery at 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows drivers to start their car from a distance, allowing them to warm up or cool down the vehicle before entering. This feature is extremely beneficial particularly during the cold winter months. The remote start system may be stopped for a variety of reasons, such as the battery being dead.

The coin-shaped battery that is inside the key fob could last between two and four years based on how frequently it is used, where it was purchased and how it is used. The date of use is displayed on the packaging or mentioned in the user manual.

If the key fob stops working after exposure to water that is clean, you should take the battery off, clean the electronic chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. In case of exposure to salty or soapy water, the chip could be damaged and you'll need to replace the key fob altogether.

If you're not sure the battery is faulty, you can test its voltage with a multimeter set to your car's voltage range, and connect it to the terminals for minus and plus. The voltage should read approximately 12-13 volts however, if it reads lower, the battery needs to be replaced. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now start.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible the receiver module has created a fault. made a post 's that part that sends a signal to the car when the key fob is activated that also acts as an immobiliser and prevents it from starting until the correct key is used.

The cause could be several reasons, such as water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, as in the chip that is located inside may be damaged. In this case, you'll need to take the device apart and clean it thoroughly using isopropyl alcohol or electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue persists then it's a good option to consult a local Peugeot specialist or locksmith. They will be able to utilize a diagnostic tool to identify the issue and fix it.

The loss of your Peugeot keys to your car is a stressful experience. However, a reputable auto locksmith can fix the problem in minutes. They can program your car and cut a brand new, working key for you. Find a locksmith near you.

Electronic chip malfunctions

The chip in the Peugeot 308 key fob is a critical part in the remote control system. If it is damaged your car may not start or receive a message that reads "anti-theft active". If this occurs, the only solution to fix the problem is to obtain a new key. Fortunately, professional auto locksmiths can provide the service in the shortest time.

The chip in the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If your Peugeot 308 key fob is exposed to soapy water, you must cleanse it immediately. You can clean the electronic component using the help of a towel that is soaked in isopropyl Alcohol. Then, you need to let the battery completely dry.

Sometimes, a key fob can stop working because of radio interference. This can be caused when other devices operate on the same frequencies as your Peugeot keyfob. This could be due to problems with the environment or objects in the vicinity of the vehicle. If you encounter this issue, it is best to visit a Peugeot dealership.

The Peugeot 207/308 Key Fob is very delicate and requires particular care. It is important not to drop or throw the key fob. If you lose it, try to find it as quickly as is possible. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Disconnect the negative cable before the positive.